10
Positioning right hinge appliance into the cabinetry
1
Coil the excess water hose and power cord flat behind the appliance.
2
Push the right hinge appliance into the right hand side of the cavity until it makes contact
with the joiner bracket.
3
Adjust the height of the appliance to align inside the cabinetry.
Refer to ‘Align appliance inside the cabinetry’ in a separate ‘Installation guide’ supplied with
your appliance.
4
Fasten the cavity bracket to the joiner bracket with two M5x12 socket head cap screws (
A
).
5
If the appliance is not flush, further loosen the top screws of the cavity attachment bracket if
required and move the bracket in a forward to back motion to suit (
B
).
6
Recheck appliance flushness (refer to separate ‘Installation guide’ booklet supplied with your
appliance). Once satisfied with flushness, tighten top screws fix an additional
#8 x 16 mush washer screw (
C
).
D
SCALE 1:10
SCALE 2:5
A
SCALE 2:5
C
B
E
F
IMPORTANT!
●
●
DO NOT install the appliance on a soft, uneven, or unlevelled floor to avoid twisting the
appliance and poor door sealing.
●
●
If using a Powered driver, use low torque setting to avoid damaging the height adjustment
system.
●
●
Ensure that the top, bottom and sidge gaps are not greater than 1/16" (1.5mm) to achieve
correct alignment.
●
●
Final alignment will be achieved once door panels have been installed and the appliance
is pushed back to sit flush with the cabinetry.
Positioning left hinge appliance into the cabinetry
7
Coil the excess water hose and power cord flat behind the
appliance.
8
Open the door of the right hinge appliance.
9
Push the left hinge appliance into the left hand side of the
cavity until it makes contact with the joiner bracket. (
D
)
!0
Open the left hinge appliance door to access the brackets (
E
).
!1
Adjust the height of the appliance to align inside the cabinetry.
Refer to ‘Align appliance inside the cabinetry’ in a separate
‘Installation guide’ supplied with your appliance.
●
●
Note: For clarity of drawing, top trims are not shown.
!2
Fasten the cavity bracket to the joiner bracket with two M5x12
socket head cap screws (
F
).
9
POSITION INTO THE CABINETRY
Note: illustration above shows appliance with RD3684/RD9121 door panel.
