Fisher & Paykel 92111, Руководство по диагностике оборудования

Страница: 18 / 33

17
CUSTOMISING
Wash cycles
Touch the power button,
Turn the dial or press the button to select the wash cycle you wish to customise, eg. 'Regular'.
Touch and hold the button of the option you want to customise, eg 'wash temp' for 3 seconds. You will
hear 2 quick beeps and the wash cycle icon will flash, the screen will display SEt.
Select your preferred setting and any other options you wish to customise for this cycle.
Touch the 'start' button to store your customised cycle. (a long beep will sound to confirm the changes
have been saved).
Controlled Cold
If the temperature of your cold water supply is very low and you choose to do a ‘Cold’ wash, you will not
get an effective wash. The ‘Controlled Cold’ option solves this problem by adding a small amount of hot
water to raise the temperature of the wash to approximately 20°C.
Enter option adjustment mode.
Select the ‘Heavy’ cycle for CleanSmart™ and FabricSmart™.
Select the 'Regular ' cycle for WashSmart™/ Eco and QuickSmart™
Select ‘Cold’ wash temperature by touching the ‘Wash temp’ button (if not already selected).
The digital display shows the temperature adjustment possible. The default setting is , which is the
same temperature as the incoming water from the supply for cold water.
To get ‘Controlled Cold’, touch the ‘More’ button until is displayed. Your washer will now adjust the
cold temperature to approximately 20°C. Each of the remaining settings equals an approximate 1°C
temperature increase or decrease from this point (excluding ).
For QuickSmart™ use the water level button to adjust to the desired temperature.
Touch ‘Power’ to save the setting (if you wish to make no other changes).
Out of balance recovery routine
When your washer is spinning it can sense if the wash load is out of balance. If an out of balance load
is detected, the washer will stop and re-try spinning one more time. If it still senses an unbalanced load
there are two options the washer can take.
Automatic recovery OFF (the default setting)
Your washer will stop, beep, and show in three phases on the display screen. You must
redistribute the load more evenly yourself. Use this option if you wish to conserve water.
Automatic recovery ON
Your washer will try to automatically correct the out of balance load. It will fill with water and agitate to
redistribute the load before trying to spin up again.
To enter Option Adjustment mode
Turn the washer on at the wall but
do not
touch ‘Power’ .
Touch and hold the
'Keylock' and 'Start/ pause'
buttons together for 3 seconds. You will hear 3 quick
beeps and the display will show
'tAP'
indicating you have entered Option Adjustment mode.