FB25033 & FB25034
Jeep® JK Wrangler
JK Grab Handles
2
2503300
Insert the grab handle into the A-pillar hole first, then
swing the top of the handle up and into position.
Loosely insert the roof bolt first. Only install a few
threads to keep the handle loose when installing the
second bolt. Again, note the factory thread sealant
may make tightening this bolt by hand difficult.
Ensure you do not cross-thread the bolt.
Install the second bolt. Moving the handle around
slightly will help align this second bolt and get it
started.
Once both bolts have been loosely installed, tighten
each one a few turns at a time until they are fully
tightened.
Repeat these steps on the driver side.
2)
INSTALL REAR GRAB HANDLES (FB25034 ONLY)
Remove the two bolts located in the picture below
using a 10mm socket:
Using the supplied washer and M6 bolt, install your
grab handle as shown. Tighten both bolts.
Repeat steps on opposite side.
3)
ENJOY YOUR NEW FISHBONE OFFROAD GRAB
HANDLES!
