FB22004
Jeep® JK Wrangler
Front Stubby Winch Bumper w/ Tube Guard
1
2200401
1)
REMOVE YOUR FACTORY BUMPER
Begin by removing your factory bumper. Ensure you
disconnect your factory fog lights before you pull
your bumper away.
2)
PREP YOUR NEW BUMPER FOR INSTALL
Before installing your bumper on your Jeep, we
suggest attaching your bumper tube, your optional
14
” light bar,
winch and fairlead (if applicable).
INSTALL YOUR BOLT-ON TUBE
Using one (1) M12 bolt, one (1) M12 lock washer,
two (2) M12 flat washers, and one (1) M12 nut per
hole, secure your tube to the top side of your
bumper. The front face of this tube will be secured
when the bumper is attached to your Jeep.
INSTALL THE FAIRLEAD BRACKET
If you wish to install a winch on your bumper, begin
assembly by attaching the fairlead bracket. Secure
the bracket to the bumper with one (1) M12 bolt,
one (1) M12 lock washer, two (2) M12 flat washers,
and one (1) M12 nut in both through holes.
INSTALL YOUR FAIRLEAD AND WINCH
We recommend installing the fairlead first as you’ll
have access to the bolts at this time. Follow the
instructions that came with your winch to install the
fairlead and winch body to the pre-drilled holes on
your new bumper.
INSTALL YOUR 14
” LIGHT BAR
If you have purchased the optional 14
” LED light bar
for your bumper, we recommend installing it after
your winch. The LED will make it difficult to get the
mounting hardware for the winch installed.
Using the supplied hardware that came in the LED
kit, secure it to the bumper between the inner
brackets.
