Fischer Panda 6500 PMS, Руководство пользователя

Страница: 36 / 214

Seite/Page 36 Grundlagen_deu.R01 - Kapitel/Chapter 3: 22.3.11
• Clean engine according to the manufacturer.
• Inject engine parts and v-belt pulleys with a preserving agent.
• Clean air filter housing and inject with a preserving agent.
• Close suction hole and exhaust opening (e.g. with tape or end caps).
• Drain sea water circuit.
• Close sea cock.
• Clean sea water filter.
• Remove impeller and store.
Attention! Carry out a deconservation before recommissioning.
3.4.3.2 Arrangements for deconservation after a medium-term standstill (3 to 6 months).
• Check charge of battery and recharge if necessary. Consider the specifications of the battery manufacturer.
• Check anti-freeze protection of the cooling water and refill if applicable.
• Drain engine oil. Renew oil filter and oil according to specification.
• Remove preservation agent of the engine with petroleum.
• Degrease the v-belt pulleys and install v-belt correctly. Check v-belt tension!
• Disconnect turbocharger oilpressure line if existent and refill clean motor oil in pipe.
• Keep engine shut-off lever in 0-position and turn engine several times by hand.
• Clean air filter housing with petroleum, check air filter and renew if necessary.
• Remove covers of the exhaust opening and the suction holes.
• Connect battery. Close battery main switch.
• Install impeller.
• Open sea cock.
• Check sea water filter.
• Keep shut-off lever at generator in 0-position and activate starter for approx. 10 sec. Make a break for 10 sec. and
repeat procedure twice.
• Visual inspection of the generator according to initial operation and start generator.
3.4.4 Arrangements at a long-term standstill / shutdown
Standstill (more than 6 months)
3.4.4.1 Arrangements for conservation:
• Check the charge of battery and recharge approximately every 3 months if necessary. Consider the specifications
of the battery manufacturer.
• Check anti-freeze protection of the cooling water and refill if applicable.
The anti-freeze protection should not be older than 2 years. The content of the anti-freeze protection should be
between 40% and 60% to ensure corrosion protection in the cooling water circuit; Refill anti-freeze if necessary.
If cooling water will be drained, for example after a conservation of the engine, no water should remain within the