Fischer Amps In Ear Amp 2 Скачать руководство пользователя страница 2

 

2

 

Actuators and Connections Front Side 

 
 
 
 
 
 
 
 
 
 

 

 
 
 
 
Description of the actuators (front side) : 

 

(1) 

On/Off Switch 

The operating voltage of the Amp is switched off on the mains side. 
When switched off, the Amp needs no power from the mains.   

 

(2) 

Control-LED

 

After switching on the Amp, the LED below the on/off power switch 
illuminated red for approx. 3 seconds and then changes to green.  
In case of defect inside the Amp or in case of overload, the internal 
relay cuts off the headphone output from the electronics and the LED 
illuminates red. If the LED does not change to green after switching on 
the Amp, there is an overload or the Amp is defective.  

 

(3) 

Earphones Output 

Earphone connection for the Fischer Amps Guitar In Ear Cable or XLR 
male 3-pole: to connect a symmetric standard microphone cable in 
combination with the Mini XLR Body-Pack. The use of microphone 
cables allows musicians to perform far off the In Ear Amp. Even the 
transmission of the earphone signal through a multicore or sub-
multicore is very easy without the need for an adaptor.  

(4)

 

Earphones Output 

Direct connection of earphones to the In Ear Amp. For use with 1/8”  

stereo connector 1/4“ 

mini connector in ear earphones, an adaptor and a 2m extension cord is 
included in the In Ear Amp package.  

 

The two earphone outputs are switched in parallel, and – unless the 
connecting impedance of 10 ohms is exceeded – can be used together. 
The maximum output power is 250 mW per side.  

 
 
 

IMPORTANT:

  The stereo jack may only be operated with a stereo earphone set with stereo jack 

connector. When using a mono jack connector, the right side of the amplifier is 
short-circuited permanently and is overloaded.  

 
 
 
 
 
 

 

Содержание In Ear Amp 2









Отзывы: