Turbo mode
This icon will be displayed if Turbo mode is currently active. While Turbo mode is active, the vehicle will remain running for a preset time
after the emergency brake has been set and the key has been removed from the ignition.
2nd Car Mode
This will be displayed while you are in 2nd Car mode. 2nd Car mode allows you to control another vehicle with the same system installed
in it. The remote needs to be coded to the other vehicle in 2nd Car mode for this feature to work.
Vibration
This icon will be displayed if the remote is set to vibrate only. While the remote is set to vibrate only the remote will not beep, even if the
alarm is triggered. The remote will still vibrate in this mode.
Alarm Clock
This icon will be displayed if the Alarm Clock function is turned on. When the clock reaches the preset time, the remote will beep and flash
the
. Press the Lock button for a half second to silence the remote.
Shock Sensor Bypassed
This icon will be displayed when the shock sensor is bypassed by holding the Lock and Unlock buttons
for 2.5 sec. Impact to
the vehicle will not be detected at this time. This icon is always displayed on starter only systems because there is no shock sensor.
Aux Mode (Alarm or alarm/starter systems only.)
This icon will be displayed while you are in Aux mode. During this time, you can activate auxiliary output 1 by pressing
then
Aux
outputs can be used to activate various systems or functions in a vehicle.
Voltage
This icon will be displayed while the remote is reporting the voltage of the vehicle or remote battery.
Temperature
This icon will be displayed while the remote is reporting the temperature of the vehicle.
General System Functions
The remote transmitter functions have been predetermined and programmed from the factory. The four button configuration allows for many functions to be
performed through a series of tapping, holding and / or multiple presses of buttons.
Sending Commands
When in range and a command has been sent, the remote will receive a page back and LCD confirmation. For example, to send a remote start command from
the 2 Way remote, hold down the button for 2.5 seconds. The remote will beep once to confirm the command has been sent and that the remote is in
range. Once the vehicle has successfully remote started, the remote will receive a command indicating the vehicle is running.
Receiving Commands
The remote pager will receive commands indicating the status of the vehicle, confirmation of sending commands and alarm notifications. For example, after
sending the lock command, the pager will receive LCD and chirp signals confirming that the vehicle has been successfully locked/armed. To see if your pager
is in range, tap the button for a half second – if the remote receives an audible and visual confirmation then it is in range.
Tap button for a half second to lock/arm and unlock/disarm. The lock icon will flash on your remote. If your vehicle is locked, tap
button
to unlock; if your vehicle is unlocked, tap button to lock.
IMPORTANT: If the alarm has been triggered (Siren is going off), you must wait up to 5 seconds before disarming the alarm – the first button tap will
shut off the alarm and the second will unlock/disarm the system.
Active Lock/Arm and Unlock/Disarm
By Firstech, LLC 18
19 By Firstech, LLC
FT-2WLCD-S-E_UserGuide.indd 19-20
2011-6-10 12:05:42
