A B C D E
N
I
C
K
DL-FM3
TX loop, not used in this install type, do not cut.
Jumper for vehicles that are not equipped with immobilizer, do not connect unless vehicle is confirmed
not equipped. If vehicle is not equipped, connect before programming to skip immobilizer learn.
NO ALARM
: Door lock connection at BCM (pin #17,
blue/green,
26-pin connector)
WITH ALARM
: Door lock/arm connections at BCM (pin #6,
yellow/green
, pin #18,
violet/green
,
26-pin connector), diode isolate the factory wires (cathode toward CM) and connect to CM output
1
2
3
SUPPORT - 1(888) 820-3690, EXT. 203
FTI-FDK1 Type 1B
Module Programming Procedure
Step 1 - Key #1 in activate IGN, if LED goes blue, you’re done
if LED goes red, wait until flashes blue then key off/on
Step 2 - If LED goes blue, you’re done, if red, insert key #2
and activate IGN, when LED is red, remove key, press
module button, and remote start vehicle, blue/done.
**See BLADE guide for more detailed instructions
FTI-FDK1 Type 1B - Installation Notes & Wiring Diagram
1
2
3
PWR
BLADE
Lock
1
16
RAP
LOCK/UNL
OCK
TRUNK RELEASE
3
1
14
17
18
6
2
1
4
6
1
6
7
8
13
C
K
K
OR
OBD-II Connector
Ignition switch
BCM
blue/black
blue
Gray
Gray
green/violet
white/black
white/red
DRIVER DOOR PIN
(+) PARKING LIGHTS
green/white
violet/white
blue/green
violet/gray
violet/green
yellow/green
LED Programming Error Codes
Module LED flashing RED during programming
1x - CAN error, check wiring
2x - VIN error, check CAN wiring
3x - Wrong firmware, confirm firmware flashed
4x - VIN error, vehicle not identified, contact support
5x - Immobilizer learn error, check RX/TX wiring
6x - KLON error, check RX/TX wiring, confirm pin positions
7x - KLON error, process failed, reset module and start over
8x - Encryption error, confirm key encryption, 80 bit detected
9x - Key in cylinder, remove and proceed
I
N
