3
2
1
4
6
7
10
A
B
C
D
E
9
5.
Assembly Instructions
FirstBIKE ”STREET“ or FirstBIKE ”CROSS“
These models have no reflective stripe on the tyre.
Contents of assembly kit bag:
No.
Qty.
Description
(3)
1 pc.
Axle for headset D = 12 mm
(4)
1 pc.
Plastic cover for headset
(5)
1 pc.
Adhesive sticker for handlebar
(6)
1 pc.
Wheel bolt (front) M 8 x 120 mm
(7)
1 pc.
Self-locking nut M 8
(8)
1 pc.
6 mm Allen wrench (for the wheel bolt)
Assembly procedure:
A
First, hold the front fork (1) and the frame (2) together
at the headset.
Insert the axle (3) into the headset from the top. It must
be inserted completely. It may help to put the wheel
bolt (6) in the axle and to tap gently with a hammer.
B
The plastic cover (4) for the headset is used to close
the opening at the top of the headset. Insert and press
into the opening - if necessary, tap gently with a hammer.
Center and place the adhesive sticker (5) on the centre
of the handlebar.
Tip:
When fitting the front wheel, turn the FirstBIKE
upside down so that it rests on the seat and handlebar.
C
The bolt M 8 x 120 mm. (6) and the nut M 8 (7), are used
for securing the front wheel. The nut fits in the hexagonal
hole on the left side of the fork. Tighten the bolt securely,
using the 6 mm Allen wrench (8)!
The brake adjustment for models with safety-stop
drum-brake system must be checked.
D
Adjust the brake cable tension with the adjustment
screw (9) so that the brake does not rub or engage
when the brake is off.
E
By adjusting the brake lever screw (10), the distance
between the handlebar and the brake lever can be reduced
(for small hands).
Recommended tyre pressure
for FirstBIKE ”STREET“ or ”CROSS“
front wheel: 1.5 bar
rear wheel: 2.0 bar
6
