FIRST TEAM SPORTS INTRUDER EZ-CRANK, Руководство по сборке

Страница: 5 / 8

19. Attach UPPER ARMS to TOP POST using (1) ½” x 7” hex bolt, (2) flat washer, (1) ½” locknut and (2)
ARM SPACER as shown. NOTE: ARM SPACERS are sandwiched BETWEEN the UPPER ARMS and the TOP
POST to prevent metal to metal contact.
20. Assemble ACTUATOR. Attach ACTUATOR HANDLE to the bottom of the ACTUATOR using small
1/8”x 1 ¼” screw and lock nut. NOTE: IF NOT ALREADY ASSEMBLED, SLIDE PLASTIC TUBE OVER
ACTUATOR BODY as shown (holes to the top).
21. Attach the ACTUATOR to the ACTUATOR BRACKET
using (1) 5/16” x 2 ½” hex bolt, (2) flat washer and (1)
5/16” locknut as shown.
22. Attach upper end of ACTUATOR to LOWER ARMS
using (1) ½” x 7” hex bolt, (2) flat washer, (1) ½”
locknut and (2) CRANK SPACER (7/8”). NOTE: ARM
SPACERS are sandwiched BETWEEN the LOWER ARMS
and the ACTUATOR to keep ACTUATOR centered on
½” bolt.
23. Lay BACKBOARD face down on a working surface.
24. Your BACKBOARD MOUNT is designed with a notch on both sides that allows the BACKBOARD
MOUNT to be bent into a “Y” shape. Bend BACKBOARD MOUNT into a “Y” shape as shown.
25. Lay BACKBOARD MOUNT onto back side of BACKBOARD lining up the four rim holes in the
BACKBOARD with the four rim holes in the BACKBOARD MOUNT. Also, make sure the holes at the top of
the BACKBOARD MOUNT match up to the threaded holes in the BACKBOARD.