3
72
72
STEP 5: ATTACH CROSS BRACES
Space frames at 72” intervals (center to center). Attach the
horizontal and cross braces using the provided hardware
(3/8”x 2” hex bolts). Bolts should be inserted from
the back side of the bracing toward the front. Use
the appropriate hardware (3/8” hex nut, lock
washer, and flat washer) to secure the bolt n the
front side.
STEP 6: SEAT PLANK ATTACHMENT
Position each seat plank onto the top of each
seat support bracket. Adjust the position of
each plank so it is positioned in the center of
the bracket and so the plank extends beyond
the center of each support frame the same at
each end of the bleacher. Attach each seat planks
to the seat support brackets using the provided
pressure clamps and provided hardware (5/16”
x 1 1/2” carriage bolt). Use two clamps per
plank attachment location. Make sure both sides
of each pressure clamp locks down and over each plank rib.
Use a 5/16 hex nut, lock washer and flat washer to secure the
carriage bolt.
If you are using a single walk plank use the slotted holes on the horizontal support as referenced in the
above drawing to attach the plank. If using a double walk plank use the remaining holes in the
horizontal support bracket. Adjust the walk planks to align with the ends of the seat planks. Use the
same pressure clamps and hardware as used on the seat clamps, to secure the walk planks.
STEP 7: CHECK FOR LOOSE BOLTS AND SCREWS
The bleacher should now be fully assembled. Go back and recheck to make sure all bolts and screws are
tight. Loose hardware is a hazard! Although, this bleacher system requires very little maintenance,
from time to time check the general condition of the bleacher. Pay close attention to welded areas and
loose bolts.
WARNING – CAUTION – WARNING
Bleachers can be dangerous! The following must always be observed with the use of this equipment.
Use of this bleacher must be on level hard surfaces only.
Never allow children to climb or play on bleachers.
