First Sales OXY2-10, Инструкция по установке и руководство пользователя

Страница: 8 / 23

7
STEP 12: For the OXY2 set the Timer Control (Figure 4a) by rotating the Skipper Wheel (Figure 4a) so
the red pointer is directly over day 1. Select the days when backwashing will occur by sliding
the metal tabs in or out. IN indicates no backwashing will occur on that day, OUT indicates
that backwashing will occur on that day.
Factory setting is to initiate backwash every third
day.
For the OXY2E proceed to STEP 13.
STEP 13: Set the current time of day. For the OXY2 start by depressing the red Time Set Button (Figure
4a) and turning the 24 Hour Gear (Figure 4a) to the desired time (note AM and PM).
For the OXY2E refer to OXY2E Series Setting Time of Day on page 11.
STEP 14: Time of Regeneration is factory set to 1:00 A.M. To adjust the time of regeneration for OXY2:
a) Unplug control valve from electrical outlet
b) Locate three screws (Figure 4b, page 6) behind the Manual Backwash Knob
(Figure 4a, Page 6) by pushing the red Time Set Button (Figure 4a, page 6) and
rotating the 24 Hour Gear (Figure 4a, page 6) until each screw appears in the cut out
portion of the Manual Backwash Knob.
c) Loosen each screw slightly to release pressure on the 24 Hour gear time plate.
d) Continue depressing the red Time Set Button and rotate the 24 Hour Gear to
expose the Regeneration Time Pointer (Figure 4a, page 6) in the cut out portion of the
Manual Backwash Knob. Keep the Regeneration Time Pointer visible in the cut out
while rotating only the time plate until the desired time of regeneration (note AM and
PM) is aligned with the Regeneration Time Pointer.
NOTE: subtract 136 minutes from
the desired time for the start of backwash to determine where the Regeneration Timer
Pointer should point.
e) Continue depressing the red Time Set Button and rotate the 24 Hour Gear along
with the Time Plate until each screw has been exposed in the cut out portion of the
Manual Backwash Knob and re-tightened. DO NOT OVERTIGHTEN. Make certain
that the backwashing filter DOES NOT regenerate at the same time with any other
water treatment equipment.
To adjust the time of regeneration for the OXY2E see Programming on Page 12.
STEP 15: Turn power or fuel supply back on to water heater.
STEP 16: When the water flowing to drain is clear, plug the control valve back into the electrical outlet
and verify the Time of Day is correct. Adjust Time of Day if necessary (see Step 13).
Installation Instructions (cont.)