First Products UA60T, Руководство оператора и список запчастей

Страница: 14 / 54

First Products UA-60T Operator’s Manual
Operation bbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
13
Operation
Note: The left and right sides of the machine are
defined as standing behind it and facing the
direction of operation.
Pre-Start
Fill fuel tank, for best results use clean, fresh
regular unleaded gasoline with an octane rating of
87 or higher.
Do Not add oil to gasoline.
Do Not overfill fuel tank. Never fill fuel tank so
that the fuel level rises above a level that is ½ inch
(13 mm) below the bottom of the filler to allow for
fuel expansion and prevent fuel spillage.
Make sure the operator understands the controls,
their locations, their functions, and their safety
requirements.
Refer to the Maintenance section and perform all
necessary inspection and maintenance steps.
Operating Instructions
Hitching Machine and Set-up
The UA-60T can be hitched to any working vehicle
desired for operation. The standard 2 inch ball
coupler is utilized for most applications. The
optional draw-bar attachment can be used in
situations where the 2” ball coupler is not feasible,
such as small utility tractors.
Once the machine is connected, the hand-held
control switch must be installed. Located under the
fuel tank, a socket receives the plug from the
control switch. Uncoil the switch and use ties as
necessary to ensure the cord does not make contact
with the vehicle in turns or the ground upon
lowering to the ground.
Leveling Aera-vator for Operation
The UA-60T is equipped with a top link connected
to the sway bar on the right side. This top link is
adjusted in or out to level the aerator during
operation.
1.
With the machine hitched at the worksite, start
the engine.
2. Lift the Auto Throttle Handle to disengage the
throttle, Figure 8, and use the control box to
lower the machine to the ground.
3. Rotate the top link as necessary to level the
machine, Figure 9.
4. Raise the machine and engage the Auto Throttle
Handle for use.
Start the Engine
1. Before starting the engine, if the machine is in
the lowered position. The Auto Throttle
Handle, Figure 8, must be lifted to disengage
the throttle.
2. On a cold engine, pull the choke knob outward
into the “ON” position.
3. On a warm engine, leave the choke in the
“OFF” position.
4. Turn ignition switch to the “START” position.
Release the switch as soon as the engine starts.
IMPORTANT: Do NOT crank the engine
continuously for more than ten seconds at a
time. If the engine does not start, allow 60
second cool-down period between starting
attempts. Failure to follow these guidelines
can burn out the starter motor.
5. If the engine is difficult to start, the throttle can
be used
momentarily . As soon as the engine
starts, cut the throttle down to the idle position.
6. If the choke is in the “ON” position, gradually
return choke to the “OFF” position as the engine
warms up.
Figure 9. Leveling Aera-vator