6
Let’s get started...
Typical set-up time: 10-15 minutes
Where to put the FD Terminal
Place the terminal on a desk or tabletop. Avoid areas with
direct sunlight, objects that radiate heat, excessive dust and
other electrical devices that can cause excessive voltage.
Loading the paper
Pop the printer cover’s latch to open the cover; then lift the
cover. Load a roll of paper (Appleton POS Grade Plus 600-2.4
is recommended) into the printer. The thermal print-side of
the paper will feed out facing the operator. Close the cover
and tear off any excess paper.
Get connected
You may choose an IP connection (DSL or cable) or dial-up. If you
choose dial-up you can use a dedicated phone line, the same line
as your fax machine or any other jack not plugged into a phone
system or LAN (Local Area Network).
6
