6
Housing Cover
Before fitting the housing cover onto the servo motor, check that the cams of the end stop
microswitches have been correctly adjusted and the connecting leads are correctly screwed tightly in
the terminals.
Check whether the actuating element is totally closed when the controller signals the corre-
sponding end stop.
Ensure that the leads are not pinched between the housing and the housing cover and the circumfer-
ential rubber sealing ring in the housing is not damaged and is correctly seated in the groove.
Screw the housing cover tight using the two housing cover screws.
Commissioning
Before commissioning the servo motor the Safety Information on Page 2 and Safety advice in
Section 2 must have been read.
Switch on the power supply to the servo motor.
Drive the servo motor via the controller or by hand and check the correct functioning of the servo
motor, the microswitches and of the actuating element.
TECHNICAL DATA
Actuating time for 90° angle of rotation:
30 s
Nominal torque:
50 Nm / 37 lb.-ft.
Holding torque:
30Nm / 22 lb.-ft.
Max. revolutions on the output drive shaft:
270°
Nominal voltage Type:
Type NX50-1:
Type NX50-2:
120V AC~± 10%, 50/60 Hz
230 V AC~± 10%, 50/60 Hz
Nominal power consumption:
15 VA
Angle of rotation limited by:
2 microswitches
Degree of protection:
IP 65 NEMA 4
Installation position:
Any
Working temperature range:
14° -140°F (- 10°C to + 60°C)
Duty cycle:
100%
Drive:
2-wire circuit
Potentiometer, single turn conductive plastic
Linearity
5kW
± 1%
Weight:
2.7 kg
Содержание NEXUS NX50-1
Страница 7: ...7 FIGURE 4 DIMENSIONS NX50 SERVO MOTOR ...
