6
Housing Cover
Before mounting the housing cover onto the servo motor, check that the cams of the end stop
microswitches have been correctly adjusted and the connecting leads are correctly screwed tightly in
the terminals.
Check whether the actuating element is totally cent closed when the controller signals the cor-
responding end stop.
Ensure that the leads are not pinched between the housing and the housing cover and the circumfer-
ential rubber sealing ring in the housing is not damaged and is correctly seated in the groove.
Screw the housing cover tight using the two housing cover screws.
Commissioning
Before commissioning the servo motor the Safety Information on Page 2 and Safety advice in
Section 2 must have been read.
Switch on the power supply to the servo motor.
Drive the servo motor via the controller or by hand and check the correct functioning of the servo
motor, the microswitches and of the actuating element.
TECHNICAL DATA
Actuating time for 90° angle of rotation:
30 s
Nominal torque:
4 Nm / 3 lb.-ft.
Holding torque:
2.5 Nm / 1.8 lb.-ft.
Max. revolutions on the output drive shaft:
270°
Nominal voltage
Type NX04-1:
Type NX40-2:
120 V AC~± 10%, 50/60 Hz
230 V AC~± 10%, 50/60 Hz
Nominal power consumption:
5 VA
Angle of rotation limited by:
2 microswitches
Degree of protection:
IP 31 NEMA 2
Installation position:
Any
Working temperature range:
14°F - 140°F (- 10°C to + 60°C)
Duty cycle:
100%
Drive:
2-wire circuit
Potentiometer, single turn conductive plastic
Linearity
5kW
± 1%
Weight:
0.7 kg
Содержание NEXUS NX04-1
Страница 7: ...7 FIGURE 4 DIMENSIONS NX04 SERVO MOTOR...
