5
CONFIG MENU DESCRIPTION
To enter the Config Menu, depress the UP and DOWN buttons simultaneously.
1.
Firmware Rev.
This is read-only. It shows the firmware revision level of the handheld commissioning tool.
2.
Code CRC
This is read-only. The CRC value is passed periodically to the InSight II scanner as part of the
hand-shaking data communication protocol.
3.
IrDA COMS ADDR
This is the communication address menu. In order for the handheld commissioning tool to com-
municate with the InSight II scanner, the IrDA communication address must be set to match the
address of the scanner. The allowable address range is 001 to 247. The default address is 247.
An Auto Detect feature is available to users who do not know the communication address of the
scanner. The Auto Detect feature is explained below.
4.
Auto Off Time (m)
The Auto Off Time menu is used to set the idle time period (in minutes) before the scanner goes
into battery saving sleep mode. This is a battery saving feature. The allowable range is 0 (always
ON) to 10 minutes. The default setting is 4 minutes.
5.
Backlight LEDs %
The Backlight LEDs menu is used to set the LCD brightness. This is a battery saving feature.
The selectable options are 0% (backlight off), 25%, 50%, 75%, and 100% (maximum bright-
ness). The default setting is 100%.
6.
Detect IrDA Addr
This menu is used to Auto Detect the InSight II scanner’s communication address. The handheld
communication tool must be aimed at the scanner while selecting this menu. The unit must
remain aimed at the scanner until the address discovery is complete. The unit will display the
scanner’s address after a successful discovery.
FIGURE 3.
BATTERY COMPARTMENT
(4) TRIPLE "A" SIZE BATTERIES
BATTERY HOLDER
BATTERY COVER
ASSEMBLED UNIT
(2) BATTERY COVER SCREWS
Warning: Do not remove batteries in a potentially explosive atmosphere