Firetide HotPort 5020-LNK, Руководство по установке

Страница: 11 / 46

Before you permanently install
5
LEDs
The panel that has the Firetide logo has these LEDs:
•
Radio 1 and Radio 2, which indicate radio status. Radio 1 is a steady green
color to indicate normal operation. Radio 2 should be dark because the
HotPort 5020-LNK does not have a Radio 2.
• Power, which is a steady green color when the device receives power. The LED
is dark when the node does not receive power.
Reset button and pressure relief valve
The reset button is on the bottom panel and is covered by a weatherproof plastic
pressure relief valve.
Antenna connectors
The left side panel has three antenna connectors for Radio 1. Rubber caps cover
the antenna connectors. You must remove and discard the rubber caps when you
install the device. For best product performance, you must connect the MIMO
antenna cable that comes with this solution and then weatherproof all three
connections.
Firetide AP20-050-MIMO-19 antennas
The HotPort 5020-LNK solution comes with two Firetide AP20-050-MIMO-19
panel antennas. The next picture shows one of the antennas and its
measurements. The antenna connectors and mount bracket are on the back of
the antenna.
12 mm
(0.5 inch)
305 mm
(12 inches)
305 mm
(12 inches)