3
6200-002
REV. A
04.16.2009
www.fireplaces.com
Assembly steps
Position the top assembly (a) of mantel upside down on a flat,
clean, non-abrasive surface. If scribe molding (d) was shipped
attached to the leg and breast board, remove it before begin-
ning assembly. Pry gently from the rear with a flat screwdriver.
Attach one leg assembly (B) to breastboard assembly by
inserting dowels and cam pin into matching holes on ends of
breastboard. Before inserting, make sure that the arrow on the
cam in breastboard points toward the edge of board as shown in
inset. (Dowels and cam pins are shipped pre-inserted in the
end of the leg assembly.)
Push down on the leg until dowels are fully inserted into the
breastboard and there is no gap between leg and breastboard.
Using a philips screwdriver, turn the cams in breastboard clock-
wise until snug. Do not rely on the cam to pull the two together.
Do not over-tighten
, as too much torque can break the cam.
Repeat the last two steps for the other leg. Your mantel is now
assembled, except for the scribe, which will be re-attached
after the mantel is permanently fixed to the wall.
Make sure the fireplace is installed according to local
codes.
In order to use the optional hearth base, the bottom of the
fireplace must have been installed 9-1/4” above the finished
floor level. A good way to verify the vertical location of the
fireplace is to place the hearth base in front of the fireplace.
Once the base is in proper position, 1/4” of lower fireplace
surround will be exposed above the top surface of the base.
1.
2.
3.
4.