TORCH CONSUMABLE PARTS SELECTION
To change the torch consumable parts use the following procedure: NOTE The tip, gas distributor, and electrode are
held in place by the shield cup. Position the torch with the shield cup facing upward to prevent these parts from falling
out when the cup is removed.
1. Unscrew and remove the shield cup from the Torch
Head Assembly. Figure B Consumable Parts.
2. Remove the tip, gas distributor, and electrode.
3. Install the electrode, gas distributor, and tip.
4. Hand tighten the shield cup until it is seated on the
torch head. If resistance is felt when installing the
cup, check the threads before proceeding.
Improper assembly or use of non standard torch parts can cause the torch head to short and may
overheat or damage the torch.
14
Part #
Description
Pkg
Qty
1445-0928
70deg Torch, 4m (13ft) Leads
1
1445-0929
Lead Assembly, 4m (13ft) Leads
1
1445-0930
70deg Torch Head
1
1445-0931
O-Ring
5
1445-0932
O-Ring
5
1445-0933
O-Ring
5
1445-0934
Electrode, Air/N2
5
1445-0935
Start Cartridge
1
1445-0936
Gas Distributor
1
1445-0937
Tip, Cutting, Air/N2
5
1445-0938
Coil Spring
5
1445-0939
Shield Cup, std
1
Figure B Consumable Parts
CAUTION
A-00780
Electrode
Gas
Distributor
Tip
Standard
Shield Cup
Torch Head Assembly
