8 Operation
© Travis Industries
1/11/2022 - 1354
4415 HO Owners
Starting the Heater for the First Time
Burn the heater at a high setting with the blower off for an extended period (up to 48 hours). This will
cure the painted surfaces.
Fumes
from the paint curing and oil burning off the steel will occur. This
is normal. We recommend opening a window to vent the room.
Condensation
may appear on the glass each time you start the heater - this is normal.
Blue Flames
will occur on the heater when it first comes on. After fifteen minutes the flames will turn
a more realistic yellow and orange color.
Verify the batteries are installed (see page 15).
Location of Controls
Direct Operation
We recommend using the remote to operate the fireplace. If you do need to operate the fireplace directly,
remove the concealment cover and screen (see page 20). Locate the heat shield and remove it (see
illustration below). NOTE: the heat shield must be in place whenever the fireplace is in operation. The
on/remote/off switch on the battery box may then be accessed.
ON (all the way left)
– Burner turns on (regardless of transmitter settings).
OFF (all the way right)
– Burner turns off (regardless of transmitter settings).
REMOTE (middle position)
– Burner is controlled by the transmitter.
NOTE
: When the battery holder switch is turned to ON or OFF, the mode settings (Flame Height, etc.) will
remain in the same state as before the switch was moved (i.e.: the IFC “remembers” the last setting). If
you wish to adjust the mode settings use the transmitter mode button to adjust the settings. The
thermostat and burner on/off operating functions will not work on the transmitter.
Most features will be
controlled by the
included remote.
°F
