Bronte Top Outlet AG Installation
6
5. ASSEMBLY INSTRUCTIONS
1. Remove all packaging and timber.
2. Remove loose parts from inside the firebox.
3. Position the base with angle steel down onto the floor protector, taking the
necessary final clearance into consideration. The base has the flue centre indicated on
the flat steel bracket. These measurements coincide with the figures on page 5 for the
heater clearances when assembled.
4. At this point a hole in the ceiling to accommodate the flue may be cut and the liners
installed.
5. Remove both front and rear top castings.
6. Place firebox on base. Secure with brackets provided.
7. Replace the rear top casting and refit the front top casting ensuring it fits neatly into
the sealed channel.
8. Refit the stainless steel flue shim in the top rear section of the firebox.
9. Assemble and fit flue and flue shield as per instructions (page 8 & 9).
10. Place the cook top grill (which must be fitted) on the top rear casting of the fire
and secure to the rear heatshield on the fire with the bolts provided.
11. A flue pipe shield
must
be fitted. The minimum requirement is for a single skin,
semi-circular, stainless steel flue shield with a reflective inner surface 1200mm high.
This should be installed so that the bottom edge of the flue shield is at the same level
as the top of the flue spigot and spaced off the flue pipe by approximately 25mm.
12. Secure the wood-burner to the floor protector for seismic restraint (refer
instructions page 7). DUE TO NZ BEING AN EARTHQUAKE PRONE
COUNTRY, IT IS IMPORTANT TO ANCHOR THE FIRENZO FIRE DOWN IN
CASE OF EARTH MOVEMENT.
13. Assemble and fit the decorative rails.
14. Fit handle as shown on diagram }
15. Fit the control knob - place the flat on the knob to
the flat on the air control shaft situated on the right hand
side of the fire. Press home firmly.
Содержание Aqualux
Страница 9: ...Bronte Top Outlet AG Installation 9...
