Firenzi FWM 1010, Инструкция пользователя, Страница: 24 / 28

24
Any necessary adjustment can be made with a spanner.
Accurate levelling prevents vibration, noise and
displacement of the machine during operation.
Some vibration is inevitable, especially if mounted on a
wooden floor.
Sprung wooden floors are particularly susceptible to
vibration. For advice, consult a builder. If possible,
always place the machine on a solid floor.
Special conditions
If the floor is carpeted or covered with crumbly or soft
material, insert a rigid support base under the feet to
prevent noise, vibration or displacement. The base
should protrude a few centimetres beyond the edges of
the machine.
Warning
The machine should NOT be placed on deep pile
carpeting.
Note
Please ensure that when the appliance is installed it is
easily accessible for the engineer in the event of a
breakdown.
In the interest of the environment
Washer-dryers and dishwashers should be connected to
the FOUL drainage system, the water will then be taken
to a sewage works for treatment before being discharged
safely into a river.
It is essential that these appliances are not connected to
the surface water drainage system as this water is
discharged directly into a river or stream and may cause
pollution.
If you require any further advice please contact your
local water authority.
SHOWER
B ATH
SINK TOILET
B I D ET
WASHIN G
MACHINE D ISHWASHER
RAINWATER
'RUN-OFF'
SURFACE WATER
D RAINS & SEWERS
UNTREATE D
D ISCHAR G E
RIVER
FOUL D RAIN
FOUL SEWERS
SEWA G E
TREATMENT
WORKS
RIVER
P098 7
TREATE D
D ISCHAR G E
2. Onto a sink outlet spigot.
If the outlet spigot has not been used before, remove
any blanking plug that may be in place.
Push the drain hose onto the spigot and secure with a
clip if required, ensure a loop is formed in the drain
hose (see diagram) to prevent waste from the sink
entering the washing machine.
The drain hose may be extended to a maximum of 4
metres. An additional drain hose and joining piece is
available from your local Service Force Centre.
The joining piece must have an internal diameter of
18mm.
Important
● Before connecting the machine to new pipework or
to pipework that has not been used for some time,
run off a reasonable amount of water to flush out any
debris that may have collected in the pipes.
Levelling
Level the appliance by raising or lowering the feet. The
feet may be tight to adjust as they incorporate a self
locking nut, but the machine MUST be level and stable.
P 1 05 1
P 11 98
L oop
P 11 9 7