16
fi regear Key West™ Outdoor Gas Fireplace
INSTALLATION
10)
Remove two screws to remove valve cover panel.
12)
Attach the label “This unit has been converted to NG” near or on top of
the serial # decal.
13)
Replace red “LPG” label with yellow “NG” label.
11)
Remove Hi/Lo pressure regulator by removing 2 screws as shown below.
Reverse steps to install NG pressure regulator.
HI/LO pressure
regulator
9)
Remove end panel (panel w/ switch) from unit.
Gas connection
@ unit
14)
Remove LP gas line, if installed - replace with NG gas line and quick
connection.
15)
Check all gas connections under normal operating pressure, for leaks,
with soapy water.
NOTE:
If soap bubbles, this would indicate a gas leak.
16)
Check inlet and outlet pressures.
17)
Check operation of fl ame control.
