Round & Square TFS Fire Pits
REV.
1-10-19 Page 10
INSTALLATION OF LAVA ROCK/MEDIA INTO BURNER PAN
Install lava rock/media into the burner pan. Ensure media is minimum of
1 to 2-inch diameter for proper operation.
Note:
Do not pour lava rock directly
from bag. Media should be placed by hand and NOT packed tight. Loose
fitting is important to ensure robust flames. Ensure rocks are free of excessive
dust. This prevents burner pan weep holes from being plugged and holding
water.
IMPORTANT
: Do not place media over top or under screen cover. Screen
must be free of any debris to ensure proper lighting of burner and to allow
proper heating of thermocouple. Cover the burner completely with media but
do not make the depth greater than 1-inch overtop of the burner port holes.
Fig. 10
Keep screen cover exposed
Lava Rock
Lava Rock
Lava Rock
Ignition Hood
Screen Cover
Fig. 8
Removing the cover from metal box.
LEARNING THE REMOTE CONTROL TO THE MODULE
The fire pit is unique that it comes standard with one remote
controlled transmitter. The handheld remote is shipped with
this system are already learned (programmed) to the module
inside the control box. Additional transmitters can be learned
to this electronic module; up to a total of three transmitters
are available. Contact Firegear to discuss additional
transmitter options or see the accessory page of this
instruction manual.
Learning the new transmitters is simple, but will require
pressing the learn button on the module. You should learn
any new transmitters before the final installation of the fire pit.
Follow the steps below:
1.
Remove the two screws securing the cover on the
control box (See Fig. 8). The cover will slide
down exposing the gas valve and control module.
2.
Find the black module attached to the inside of the
control box. Locate the “Learn Button” on the bottom
of the module.
3.
Once the Learn button is located, press and release
the button once. You will hear a beep indicating that
the module is ready to receive a transmitter code
(See Fig. 9)
4.
Take the transmitter and press the OFF button. You
will hear a series of rapid beeps indicating the module
has accepted the new code.
NOTE
: A maximum of three (3) codes can be programmed to
the module. After a total of three (3) codes have been
programmed the memory is full and will not accept any
additional codes. To clear all codes, press and hold the learn
button for 10 seconds. The module will beep three (3) times
indicating the memory is clear of all codes. After codes have
been cleared see to Step #3 above to re-learn transmitter.
Fig. 9
Learn button location
Fire Pit Valve Box
Pow
er S
crew
driv
er
Lear
n Butt
on
AUX
POWER
PEN
MODULE
INSIDE VALVE
BOX
