Fig. 9
Removing the cover from metal box.
REV. 10-10-12 Page 8
LEARNING THE REMOTE CONTROL TO THE MODULE
The
fire
gear Fire Pit is unique that it comes standard with one
remote controlled transmitter (Model RCAF-3). The handheld
remote is shipped with this system are already learned (pro
-
grammed) to the module inside the control box. Additional
transmitters can be learned to this electronic module; up to
a total of three
fire
gear transmitters are available. Contact
fire
gear to discuss additional transmitter options or see the
accessory page of this instruction manual.
Matching new transmitters is simple, but will require pressing
the learn button on the module. You should learn any new
transmitters before the final installation of the
fire
gear Fire
Pit. Follow the steps below:
1.
Remove the two screws securing the cover on the
control box (See fig. 9). The cover will slide
down exposing the gas valve and control module.
2.
Find the black module attached to the inside of the
control box. Locate the “Learn Button” on the bottom
of the module.
3.
Once the Learn button is located, press and release
the button once. You will hear a beep indicating that
the module is ready to receive a transmitter code
(See fig. 10)
4.
Take the transmitter and press the OFF button. You
will hear a series of rapid beeps indicating the module
has accepted the new code.
NOTE
: A maximum of three (3) codes can be programmed
to the module. After a total of three (3) codes have been pro
-
grammed the memory is full and will not accept any additional
codes. To clear all codes, press and hold the learn button for
10 seconds. The module will beep three (3) times indicat
-
ing the memory is clear of all codes. After codes have been
cleared see to Step #3 above to re-learn transmitter.
Learn Butt
on
AUX
POWER
PEN
MODULE
INSIDE FIRE PIT
METAL BOX
Fire Pit Valve Box
Fig. 10
Learn button location
