Firegear B360EXSSA11-N, Инструкция по установке и эксплуатации

Страница: 12 / 20

12
OPERATION
FOR YOUR SAFETY
– READ BEFORE LIGHTING
FIGURE 27
– REAR VIEW
- REVOLUTION 360EXSS NATURAL GAS
Shown in black steel
– actual unit is constructed of 304 Stainless Steel
!!! WARNING !!!
Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance, and replace any part of the control system and any
gas control that has been under water.
This appliance, depending on model, uses a piezo igniter, to
light the safety pilot. The piezo igniter is located above the gas
valve control knob. Pilots may also be lit by long hearth match,
hand fire starter, or book match clip extender. All units must
be lit by a Safety Pilot. Pilot is located at the rear, left-center of
the unit. ( See Figure 27, 28, & 29 )
Follow these instructions exactly when lighting the appliance.
BEFORE LIGHTING, smell around the appliance area for gas.
Be sure to smell next to the floor, as LP gas is heavier than air
and will settle to the floor. Use only your hand to rotate the gas
control knob. Never use tools. If the knob will not turn by
hand, do not try to repair it; call qualified service technician or
installer. Force or attempted repair, may result in a fire or
explosion.
FIGURE 29
– ODS PILOT
OPERATION continued
!!! WARNING !!!
All gas burning appliances produce smoke and carbon
monoxide gas during operation. These fumes can be harmful
if the appliance is used in any other than a fully vented, or
certified vent-free fireplace.
!!! WARNING !!!
A fireplace screen must be in place when this appliance is in
operation. Unless other provisions for combustion air are
provided, the screen shall have an opening(s) for introduction
of combustion air.