Reset
In rare cases, resetting the belt pack may become necessary.
Plug the charger plug into the charger jack. The system will reset. Both red and green
LEDs will illuminate for approximately two seconds and then the belt pack will resume
normal operation.
NOTES:
1. In case the battery is deeply discharged, no LED indication will be possible
until the battery is partly charged to an operable voltage level.
2. Plugging the charger plug into the belt pack at any time will cause the belt
pack to reset even when it is linked to a base station. Resetting a connected
belt pack will result in losing the link for about 10-12 seconds.
3. Resetting the BP5-10 belt pack will cause the belt pack to resume normal
operation in the stand-by (power-off) mode. Press and hold the power button
for 3-4 seconds to turn the belt pack power on.
Care and Maintenance
Never remove the charging cable from the belt pack by pulling on the cord. The belt
pack should be unplugged at the jack location by pulling the charger plug from the
jack.
Wipe the external surfaces of the belt pack with a mild soap and water mixture only.
Do not store in direct sunlight or in areas of high temperature.
Specifications
Speaker Output
Amplifier Frequency Response…………….…… 300Hz - 3.4 KHz, +/- 3dB
Impedance Range……………………………………………… 150-600 ohm
Weight……………………………………………………………………
19.50z
Headset Jack
5-conductor jack (mates with U-384/U plug) to fit Firecom headsets
Microphone Input
Frequency Response……………………………….. Microphone dependent
Max. Amb. Noise Level…………………………………. Headset dependent
MIC Sensitivity range…………………………. 20-80mv, at 1KHz, 94dBSPL
DC Bias………………………………………………... 9V through 1K resistor
Frequency range……………………………………………... 300Hz – 3.4KHz
Noise Canceling……………………………………… Microphone dependent
S/N ratio……………………………………………….. Microphone dependent
Output Impedance…………………………….………………… 50-2.2K Ohm
Due to continuous product improvements, all specifications are subject to
change without notification.
