Firecom 5000D Series, Руководство по установке и эксплуатации

Страница: 5 / 36

5
SYSTEM ORIENTATION
This section provides an overview of the 5000D Series Digital Intercom System and an introduction to its individual
components. Figure 2 shows a typical system. Refer to this diagram for each component.
INTERCOM
The main control unit for the 5000D Series Intercom System which contains all the controls and interface circuitry.
WIRELESS BASE STATION
A Module which provides wireless communications between wireless headset users, belt pack users, and Intercom and
radio users.
2-WAY RADIO
The existing 2-way radio in the apparatus.
MOBILE RADIO INTERFACE CABLE
Provides the interface connections between the 5000D Series Intercom Unit and the 2-way radio in the apparatus. There
are many cable assemblies available; the cable needed depends on the make and model of your radio. Contact your
local Firecom Dealer for more information regarding an Interface Cable specific to your radio.
POWER CABLE ASSEMBLY
Provides the power connections for the 5000D Series Intercom Unit. The power connections should be made at the
same place as the power connections for your radio.
HM-10 HEADSET MODULES
The wired headset will be plugged into the Headset Module (HM-10) which is the standard module for headset-to-
system interface.
PP-20 PUMP PANEL MODULE
A water-resistant Headset Module used on the exterior of the apparatus (e.g. at the Pump Panel, at the tail-board, etc.).
CA CABLES
Six-conductor flat cable which connects the 5000D Series Intercom Unit to the Wireless Bases, Headset Module, and the
Remote Head.
REMOTE HEAD INTERCOMS
Remote Head Intercoms can be connected to the main control unit to control the unit from a remote location. Up to 5
remotes heads can be connected to the Digital Intercom by utilizing an RJ-12 splitter or by splicing into the 6 conductor
modular cable.
Figure 2