8
Performance Feedback While you Swim
The Firebelly device provides you with the performance feedback you need when you need it.
Feedback primarily takes the form of spoken announcements. For example, if you have
configured the device to announce your split time every 2 lengths you would hear the device
announce your time after you make your turn
(e.g. “thirty two point six”) and start swimming
length number 3.
Getting Ready
After turning the device on (top button), make sure the device is on and charged
– i.e. blinking
green. Select the optimal location to wear the device based on your stroke style and comfort
(see
). Under the goggle strap and in front of the ear is the preferred location. Due to
the bone conduction capabilities of the device, it also works well behind the ear. Make sure
wherever it is located that it is straight up and down in order to get accurate performance.
Note it is recommended you put the device on in while the pool to avoid extreme shocks (e.g.
dropping the device)
4
.
Figure 5
Swimming
You can press top button to put the device into swim detect mode any time. The device will be
flashing blue. Generally it is better to wait until the device is in place and you are ready to start
the set so Firebelly doesn’t detect your preparation actions as swim motions (e.g. adjusting
goggles, cap, etc.). About 5 seconds after
entering swim detect mode you will hear “Start when
ready!
”, after which you can start swimming any time. If you wish to change the mode, use the
+ / - buttons on the side to select the mode you want. Mode can be selected either before or
after entering swim detect mode.
Now just swim as you always do and the Firebelly device will give you the appropriate audio
feedback based on the mode selected. Once in swim detect mode, all detection of starting,
stopping, rest periods, etc. is automatic
– you do not need to press any buttons to stop the
clock.
4
Damage due to dropping the device is not covered by the product warranty.
