Contact us for assistance: (866) 985-7877 | www.wtliving.com
11
OPERATING INSTRUCTIONS
CAUTION
Do not attempt to operate until you have read and under
s
t
a
nd all General Safety
Information in this manual
, all
assembly is complete
,
and
leak test
has been
performed.
BEFORE TURNING GAS SUPPLY ON:
1. Your fire pit was designed and approved for outdoor use only. Do NOT
use it inside a building, garage, or any other enclosed area.
2.
Make sure surrounding areas are free of combustible materials, gasoline,
and
other flammable vapors or liquids.
3.
Ensure that there is no obstruction to air ventilation. Be sure all gas
connections
are tight and there are no leaks.
4.
Be sure the cylinder is clear of debris. Be sure any component removed
during
assembly or servicing is replaced and fastened prior to starting.
DANGER!
FOR OUTDOOR USE ONLY
CARBON MONOXIDE HAZARD
Never use this product inside a house or other
unventilated or enclosed areas. This fire pit
consumers air (oxygen). Do not use in
unventilated or enclosed areas to avoid
endangering your life.
WHEN FIRE PIT IS ON:
Burner will display tongues of blue
and yellow flame. These flames
should not produce thick black
smoke, indicating an obstruction of
airflow If excessive flame is
detected, turn off fire pit and
consult the
Troubleshooting
section of this manual.
OPERATING THE UNIT — LIGHTING AND EXTINGUISHING
FOR YOUR SAFETY, READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion
may result, causing property damage, personal injury, or loss of life.
1.
BEFORE LIGHTING, smell all around the unit area for gas. Be sure to
smell
near the floor, because some gas is heavier than air and will settle on the
floor.
2. IF YOU SMELL GAS:
a. Shut off the gas to the appliance.
b. Extinguish any open flame.
c. If odor persists, immediately call your gas supplier or the fire
department.
3. Use only your hand to depress or turn the gas control knob. Never use
tools. If the knob will not depress or turn by hand, DO NOT try to repair it.
Call a qualified professional service technician. Force or attempted repair
may result in fire or explosion.
ELECTRONIC IGNITION INSTRUCTIONS
1.
STOP!
Read the safety information above.
2. Push and slowly turn the control knob to the HIGH position.
3. Hold igniter to light the burner. (The electric ignition will produce a soft snapping/crackling sound.) Once burner
lights, continue to depress control knob for 45 seconds.
4. Observe the flame height when lit. Flame should reach between 3 and 13 inches in height. Overly short or tall
flame can indicate a problem.
5. If the burner does not light, immediately turn the control knob to the OFF position.
6. Wait approximately five minutes for gas to dissipate. While you wait, check the battery behind the igniter button.
Replace if necessary. Check gas supply. Replace gas cylinder if necessary. Repeat steps 1-4 above.
7. If burner fails to light again, turn the control knob to the OFF position and contact your dealer or gas supplier.
8. To extinguish your gas burner, turn the control knob to the OFF position. Be sure the control knob is turned fully
off to avoid any gas leakage.
9. Turn off gas supply at the gas cylinder.
