ASSEMBLY
4
3
CARE:
When wind guard is completely cool, it may be cleaned with a soft cloth or paper towel and standard glass cleaner.
Never spray cleaner or water on a hot wind guard, as it could crack or shatter.
Store the wind guard in a safe place during poor weather or when not in regular use.
Hardware Used:
D
B
ottom B
racket
x4
Carefully (using two people if possible) turn the
assembled wind guard upright. Gently set the glass guard
onto the fire pit table, positioning the feet flat and level
outside the edges of the burner. Check that the glass
panels are not directly touching the tabletop, and are held
off slightly by the foot pads of the lower brackets. Ensure
that the gripper foot pads are not sitting directly on the
fire bowl.
Be aware that the glass and hardware may become warm
or hot after prolonged burning of the fire pit and take
reasonable precautions to avoid burns.
Loosen set-screws and carefully slide
Bottom Bracket
D
onto
each panel joint, with foot pad pointed up.
Position the bottom edge of the metal
Bracket
flush with the
edge of the glass panels, adjusted so the foot pad will hold
the assembled guard slightly off the table surface when
placed upright.
Check that the silicone screw pads are in place, then secure
both set-screws, making sure not to over-tighten.
Secure three remaining brackets using the same procedure.
Contact us for assistance: (866) 985-7877 | www.balkenehome.com
5
