Contact us for assistance: (866) 985-7877 |
www.balkenehome.com
CARE AND MAINTENANCE
WARNING
FOR YOUR SAFETY
•
Do NOT touch or move heater for at
least
45 minutes after use.
•
Reflector is hot to the touch.
•
Allow reflector to cool before
touching.
To enjoy years of outstanding performance from your heater, make sure you
perform the following maintenance activities on a regular basis:
KEEP EXTERIOR SURFACES CLEAN.
1.
Use soapy water for cleaning. Never use flammable or corrosive
cleaning agents.
2.
While cleaning your unit, be sure to keep the area around the burner
and
control compartment dry at all times. Do not submerge the
control valve
assembly. If the gas control is submerged in water, do
NOT use it. It must
be replaced.
3.
Air flow must be unobstructed.
K
eep controls, burner, and circulating
air passageways clean. Signs of possible blockage include:
4.
Gas odor with extreme yellow tipping of flame.
5.
Heater does NOT reach the desired temperature.
6.
Heater glow is excessively uneven.
7.
Heater makes popping noise.
8.
Spiders and insects can nest in burner or orifices. This dangerous
condition can damage heater and render it unsafe for use. Clean
burner holes by using a heavy-duty pipe cleaner. Compressed air
may help clear away smaller particles.
9.
Carbon deposits may create a fire hazard. Clean dome and burner
screen with warm soapy water if any carbon deposits develop.
Note: In a salt-air environment (such as near an ocean), corrosion
occurs more quickly than normal. Frequently check for corroded areas
and repair them promptly.
TIP FOR STAINLESS STEEL MODELS:
Use high-quality automobile wax to help maintain the appearance
of your heater. Apply to exterior surfaces from the post down.
DO NOT apply to emitter screen or domes.
STORAGE
:
Between uses:
• Turn control knob OFF.
• Disconnect LP source.
• Store heater upright in an area
sheltered from direct contact
with inclement weather (such
as rain, sleet, hail, snow, dust
and debris).
• If desired, cover heater to
protect exterior surfaces and
to help prevent build-up in air
passages. Never leave LPG tank
exposed to direct sunlight or
excessive heat.
Note:
Wait until heater is
cool before covering.
SERVICE:
Only a qualified service person
should repair gas passages and
associated components.
Caution: Always allow heater
to cool before attempting
service.
20
