Before You Begin
Parts List
Check to make sure you have the following:
Remove all parts from packing and check to make sure you have all parts described in “Before You Begin” section above.
Spread out parts on a soft, level surface to avoid scratching parts.
Step
1: Unpack parts carefully and set aside on a flat, non-abrasive surface.
Step
2: Choose a level location for set up.
Step
3: Connect Iron Stand Part I (E) to Iron Stand Part II (F)
using
screws (H) and
nu
ts
(J)
. See
Fig.1.
Step
4: Put
D
ecorative square top (D) on something soft and flat (cardboard etc.) with
tile
side down. Connect
stand (E&F) to
D
ecorative
square
top (D) using M6x10 screws (I)
.
See
Fig.
2.
Step5: Turn over the entire assembl
ed fire pit
and make sure it is level with the
floor
. P
lace
F
ire bowl (B) into the
assembled stand (E&F&D).
Step6: Place
W
ood grate (C) into the
Fire
bowl (B).
Step7: Place
M
esh screen (A) on the top of the
Fire
bowl (B).
CAUTION: NEVER use your hands to open or close the screen when hot
. U
se the
Fire screen
lift tool (G) provided.
Your fire pit is now ready for use.
Preparation
Assembly Instructions
A. Mesh
f
ire screen with handle
1 pc
B. 23
"x
23’’
Fire
bowl
1 pc
C.
W
ood grate
1 pc
D. Decorative square top
(with 12
pcs of yellow tile)
1 pc
E. Iron Stand Part I
2 pcs
F. Iron Stand Part II
2 pcs
H. M6x20 screw
8 pcs
I. M6x10 screw
4 pcs
J. M6 nut
8 pcs
G.
Fire screen lift tool
1 pc
Assembled Fire
P
it
Fig. 2
D
E
F
Fig. 1
J
F
E
H
2
