Fire-Lite ECC-100, Инструкция по эксплуатации

Страница: 35 / 112

Emergency Command Center Manual — P/N LS10001-000FL-E:D 9/3/2014 35
Input/Initiating Circuits Installation
2.5.3 NAC Follower Input
For fire-only applications, the NAC follower input may be used to trigger the onboard NAC.
Strobes driven by the onboard NAC must be visibly isolated from FACP NAC(s).
This can be accomplished by connecting the NAC Follower input at TB18 of the control board to
the FACP's NAC output. The ECC-50/100 NAC output will then follow the FACP's NACs. A
redundant pair of terminals is provided at TB18 for convenient connection of an EOL resistor, or
for wiring to any additional equipment requiring this feature (such as an FCPS-FS6/8 remote power
supply).
The NAC Follower input is power-limited (Class 2) (refer to Section 2.12, “UL Power-limited Wir-
ing Requirements”, on page 49) and supervised by the host FACP. Supervision requires that a
4.7 K

EOL resistor be connected to the last device in the NAC Follower chain.
2.5.4 Night Ring
The external audio input allows a building’s Private Branch Exchange (PBX) to activate the ECC-
50/100. Connections need to be made to TB16 on the main control board and to TB5.1 and TB5.2
on the display board. Refer to Section 1.2.2 for electrical specifications to the external audio input.
from FACP NAC (or NAC Follower
output) or previous device
to next device
4.7K ELR needed for
last device in chain.
alarm polarity shown
TB18
1 2 3 4
Figure 2.10 NAC Follower Wiring
ECC-50/100 Main Control Board
ec
ct
b1
8.
w
m
f
+ -
PBX
audio out
external audio input
GND
In
contact
closure output
TB5 on display
board
TB16 on main
control board
ec
ct
b1
6.
w
m
f
Figure 2.11 Night Ring Wiring