2.
WHAT’S INCLUDED IN THE PACKAGE
–
dive light
–
Li-ion accumulator with protective electronics
–
charger
–
black silicon ring for the light head
–
service lubricant
–
user manual
3. BEFORE THE FIRST USE
Carefully read the enclosed instructions and, in case of doubt, please contact your dealer!
The battery is supplied in a 50% charge state for storage and ideal initial capacity adjustment. It must be fully
charged before first use.
4. CHARGING
Charge the dive light at an ambient temperature not exceeding 25° C and in a dry environment. Never charge at
high ambient temperatures, in direct sunlight or in frozen environment! The supplied accumulator is equiped
with the undercharging and overcharging protection.
Charge the dive light only by the supplied charger!
Charging procedure:
1. Plug the charger into the power socket - the light is green. The supplied charger can be
connected to a 220V or 110V supply.
Never connect the charger to a non-matching voltage!
Be careful not to break the wires. If the conductors are obviously damaged, never use the
charger.
This may result in electric shock and irreparable damage to the lamp!
In such cases,
the warranty claim will not be accepted.
2. Insert the battery into the charger. Pay attention to the correct polarity, ie. + battery pole on + charger
contact and - battery pole on - charger contact.
Insert the battery into the charger with the label facing up,
otherwise the protective film may be damaged
. When the charging cycle is started, the charger indicator light
turns red and the battery is charging. When the light comes on green, the battery pack is charged at about 90%.
To get full battery capacity, you can keep it charging (the complete charging cycle lasts for about 3 hours when
the batteries are fully discharged).
3. Remove the battery from the charger and then disconnect the charger from the socket, save the power.
When disconnecting the charger from the mains and disconnecting the light contacts from the charging
adapter, never pull the charging cable but hold the plug at the end of the cable and pull it out of the socket!
Important warning
Li-ion sources do not have the so-called memory effect.
We recommend recharging the battery after every use,
regardless of whether it is fully discharged or not.
5. LIGHT CONTROL, DESCRIPTION OF FUNCTIONS, USAGE
Unscrew the torch head from the delrin body. Insert a charged battery into the torch body. Pay attention to the
correct polarity, ie. + battery pole upwards towards the head of the lamp and - the battery pole down towards
the bottom of the torch body.
Completely screwing the head into the lamp body will light it up. By briefly unscrewing the head from the torch
body by about half a turn it will switch off.