71-0156
Page 7
4215-136
Rev. 03
10/21/2022
12.
Secure the side wall to the back wall panel with (3)
3” Torq screws.
Install one screw on the top of the wall, one in the middle, and one
on the bottom.
13.
Install the remaining wall panel up to the door panel. You will
install the door panel next to the right front wall panel before you
install the final wall panel.
14.
Secure left front wall panel to the left side
wall with three 3” Torq screws. Ensure the
tongue and groove are tight at the interior
corner when screws are installed.
Top Plate Installation
15.
After installing the wall panels, install the 1” top plate. This top
plate aligns and locks the top of the wall panels together.
Note: Before installing top plates, ensure all panels are fully
connected on top and on the corners.
16.
Install back top plate first. Matching top plate
with the corresponding wall panels number.
Install notched ends facing up.
17.
Install the left and right wall top plates notched end facing down.
So, they fit into the notches of the corresponding top plate.
18.
Firmly press down (use a hammer if needed) until top plates rest
on the framework of the wall panels.
19.
The top of the plate should be flush with the top of the interior
tongue and groove.
20.
Secure top plates using the 2” Torque screws. Install one screw in
each corner and one screw in the center of each wall.
21.
Install
½” self
-adhesive foam weather stripping on
the top plates. Adhesive side down to the top plate.
22.
Install corner caps to each corresponding wall panel
make sure corner cap is flush with base of wall.
Secure using Brad nails or finishing nails (not
supplied),
