Finn HydroSeeder T60 II, Руководство по эксплуатации и каталог запасных частей, Страница: 7 / 60

3
or stops. Never operate on a slope or a hill that may
endanger the driver and/or the operator(s). All per-
sonnel should review and be familiar with stop/start
signals between the driver and operator(s) before
going into operation. Only the operator should be
located on the platform during operation.
6. Operator(s) of equipment
should never ride on the
machine at speeds of
greater than 5 MPH (8
kmh).
7. Never operate machine
in an enclosed area with-
out venting the engine
exhaust of both the equip-
ment and vehicle on which
the equipment is mounted.
Deadly carbon monoxide
fumes can accumulate.
8. Never operate this or any other machinery when
fatigued, tired, under the influence of alcohol, ille-
gal drugs or medication. You must be in good
physical condition and mentally alert to operate this
machine.
9. Never modify the machine. Never remove any part
of the machine (except for service and then reinstall
before operating).
10. Use proper means (steps,
ladder) for mounting
and dismounting of the
machine. Never mount
or dismount a moving
machine.
III. SLURRY APPLICATION:
1. Do not aim discharge spray toward power-lines,
transformers, or other high
voltage electrical conduc-
tors. Also do not aim dis-
charge spray towards peo-
ple, animals or anything
other than the intended
application area.
2. Never engage the clutch
when both the recirculation
and discharge valves are
closed. Operation with both
valves closed will result in
extreme heat generation
that could cause severe
bodily injury and damage
to the equipment.
3. Recirculation valve must be open and material flow-
ing back into the tank when using the remote valve.
A closed or plugged recirculation line will cause
extreme heat in the pump or discharge lines which
will result in severe bodily injury and damage to
the equipment.
4. During application through a hose, high pressure
can be exerted at the end of the hose. Hose holding
personnel must establish good footing. The operator
should apply gradual pressure to the hose only after
hose holding personnel are firmly positioned and
have firm control of the hose. Additional personnel to
direct hose may be necessary if working on slopes.
The proper technique for hose holding personnel is
to firmly grasp the hose over the shoulder or under
both arms. Never hold the hose so it goes between
the legs. If the hose holding personnel finds that
it is uncomfortable for him to handle the hose by
himself additional hose holders should be positioned
at the end of the hose.
5. Plan application so that the furthest area is covered
first; working back toward the HydroSeeder®, so that
the individuals are not walking back over slippery
ground.
6. Before opening any valves
or pipe clamps shut
machine down and check if
material in the pipe is hot.
If hot, do NOT open valve
or pipe clamps as the hot
material may cause severe
personal injury. Allow to
cool and open with cau-
tion.
7. Except when loading materials keep loading hatch
lid closed to protect operator and prevent splashing
of wet material onto the tank top.
8. Wash off spillage of slippery mulch or slurry additive
from the tank top and platform before operating
equipment.