English
- 7 -
Inserting the Batteries into the Remote
Control
1.
Lift the cover on the back of the remote upward
gently.
2.
Install two AAA batteries. Make sure to match
the + and - ends of the batteries in the battery
compartment (observe the correct polarity).
3.
Replace the cover.
Connect Power & Antenna
IMPORTANT:
The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow the
TV set to reach the ambient room temperature before
you connect the set to the mains. Plug the aerial cable
into the ANT socket on your TV.
Switching On/Off
To Switch the TV On
Connect the power cord to the 220-240V AC, 50 Hz.
To switch on the TV from standby mode either:
Press the “
” button,
P/CH+ / P/CH-
or a numeric button
on the remote control or press the control switch located
on the left side of the TV.
To Switch the TV Off
Press the “
” button on the remote control or press and
hold the control switch on the TV until the TV shuts down.
The TV will now switch to standby mode.
To power down the TV completely, unplug the power
cord from the mains socket.
Note: When the TV is switched to standby mode, the standby
LED can blink to indicate that features such as Standby
Search, Over Air Download or Timer is active. The LED can
also blink when you switch on the TV from standby mode.
First Time Installation
When turned on for the
fi
rst time, the “language
selection” menu appears. The message “
Welcome
please select your language!
” is displayed and all
language options are listed alphabetically.
Press the “ ” or “ ” button to highlight the required
language, press OK button to select. “First Time
Installation” appears. Use “ ” or “ ” button to set the
required country, and press “ ” button to select Search
Type. Use “ ” or “ ” to set the desired search type.
Available search types are digital and analog, digital only
and analog only. When set, press “ ” to select Teletext
Language. Use “ ” or “ ” button to set the “Teletext
Language” and select “Scan Encrypted” using “ ” or
“ ” button. You can set
Scan Encrypted
as
Yes
if you
want to scan coded stations.
Press
OK
button on the remote control to continue and
the following message will be displayed on the screen.
A02_[GB]_MB90_5103UK_DVBT_C_3D_BASIC IB_42127LED_GOLD18_10079332_50220173.indd.lnk 7
A02_[GB]_MB90_5103UK_DVBT_C_3D_BASIC IB_42127LED_GOLD18_10079332_50220173.indd.lnk 7
30.07.2012 18:51:25
30.07.2012 18:51:25