Finlux 24-FDMA-5660, Руководство пользователя

Страница: 20 / 78

English - 19 -
Software Upgrade
<RXU79LVFDSDEOHRI¿QGLQJDQGXSGDWLQJWKH¿UPZDUH
automatically via the broadcast signal or via Internet.
Software upgrade search via user interface
On the main menu select System>Settings and then
More . Navigate to Software upgrade and press the
OK button. In Upgrade options menu select Scan
for upgrade and press OK button to check for a new
software upgrade.
If a new upgrade is found, it starts to download
the upgrade. After the download is completed
confirm the question asking about rebooting the
TV by pressing the
OK to continue with the reboot
operation.
3 AM search and upgrade mode
Your TV will search for new upgrades at 3:00 o’clock if
Automatic scanning option in the Upgrade options
menu is set to Enabled and if the TV is connected
to an aerial signal or to Internet. If a new software is
found and downloaded successfully, it will be installed
at the next power on.
Note: Do not unplug the power cord while led is blinking
during the reboot process. If the TV fails to come on after the
upgrade, unplug, wait for two minutes then plug it back in.
Troubleshooting & Tips
Tv will not turn on
Make sure the power cord is plugged in securely to
wall outlet. Check if batteries are exhausted. Press
the Power button on the TV.
Poor picture
‡ Check if you have selected the correct TV system.
‡ Low signal level can cause picture distortion. Please
check antenna access.
‡ Check if you have entered the correct channel
frequency if you have done manual tuning.
‡ The picture quality may degrade when two devices
are connected to the TV at the same time. In such
a case, disconnect one of the devices.
No picture
‡ This means your TV is not receiving any transmission.
Make sure the correct source has been selected.
‡ Is the antenna connected properly?
‡ Is the antenna cable damaged?
‡ Are suitable plugs used to connect the antenna?
‡ If you are in doubt, consult your dealer.
No sound
‡ Check if the TV is muted. Press the Mute button or
increase the volume to check.
‡ Sound may be coming from only one speaker. Check
the balance settings from
Sound menu.
Remote control - no operation
‡ The batteries may be exhausted. Replace the
batteries.
Input sources - can not be selected
‡ If you cannot select an input source, it is possible
that no device is connected. If not;
‡ Check the AV cables and connections if you are
trying to switch to the input source dedicated to the
connected device.
Recording unavailable
7RUHFRUGDSURJUDPPH\RXVKRXOG¿UVWFRQQHFWD
USB disk to your TV while the TV is switched off.
You should then switch on the TV to enable recording
feature. If you cannot record, try switching off the TV
and then re-inserting the USB device.
USB is too slow
If a “ USB disk writing speed too slow to record ”
message is displayed on the screen while starting a
recording, try restarting the recording. If you still get
the same error, it is possible that your USB disk does
not meet the speed requirements. Try connecting
another USB disk.