www.HavocAmps.com
Mild
H
AVOC
Preamplifier (Model 15209): User’s Manual 15166 Revision 0
6
6.
LEVEL
Use the
LEVEL
control (along with the
GAIN
control) to adjust
the overall signal level sent to the line output.
User’s Tip:
It is recommended to begin by setting the
LEVEL
control to minimum
and increasing until the volume/level is acceptable. The output stage of
the amplifier is designed to clip once the output signal reaches over 1
Vrms; this is important to avoid damage to guitar pedals and other gear
you might plug into.
7.
POWER
It turns it on when you want to rock, and turns it off when you
are finished.
REAR PANEL
8.
POWER
Plug the included IEC power cable in here, and plug the other
end into a grounded 120 VAC outlet. Be sure to use a properly
grounded outlet. Do NOT remove the ground pin from the
power cord, due to shock hazard.
9.
FUSE
The power cord receptacle contains a fuse for protection. Only
replace the fuse when the power cord has been disconnected,
8 9
10
