Installation
QR110 is powered by the master terminal, thus no extra power supply is required.
1
1
2
2
3
4
Veri
fi
cation
QR110 reads the ID from the QR code or card and sends the information to the master
terminal for veri
fi
cation. QR110 is a slave unit and it does not store any information. Therefore,
card registration must be done at the master terminal only.
1
2
Verify
CARD: 0003837885
USER ID: 00001
VERIFIED
Verify PIN Card
No enroll
3
4
5
Make sure the device is on standby
mode and ensure that you have
created/enrolled the QR code/
card at the master terminal prior
to usage.
Present your QR code to the camera area for
veri
fi
cation. If you are using card, wave the card at
the card scanning area. Note that the LED light
indicator will turn to green if the veri
fi
cation is
successful.
Veri
fi
cation •
Master terminal indication
Once the master terminal veri
fi
es the QR code/card, the prompt “Verify” will be displayed.
If the QR code/card has not been enrolled or if there is something wrong with the QR
code/card, the master terminal will prompt an “oo..oo..” sound indicating veri
fi
cation failure.
QR110
s u p p o r t @ f i n g e r t e c . c o m
QR110
s u p p o r t @ f i n g e r t e c . c o m
Green light
Green light
Separate the
QR110 front
panel from its
body.
Install the
electrical
protective
case on the
wall.
Install QR110 body
to the electrical
protective case.
Please ensure that
you have already
connected all wires
correctly before
you tighten up all
of the screws.
Place QR110
front panel
onto the
body.
D0
D1
GND
VCC
Rear of QR110
