11
CONTENTS
CONTENTS
CONTENTS
CONTENTS
TCMS V2 Online Activation
TCMS V2 is a genuine software by FingerTec. Every FingerTec access control model
comes bundled with a unique license key. To start using the terminal with TCMS
V2, you must connect the terminal to TCMS V2 and perform online activation.
TCMS V2 reads the serial number of your terminal and sends it for verification at
the FingerTec server via Internet.
In case you do not have an Internet connection, you would need to do offline acti-
vation. Please send the serial number and models of your terminals to your local re-
sellers or
to request for a product key and activation key.
Installation and Setup of TCMS V2
Install TCMS V2 in a PC that fulifills the software’s minimum requirements. Refer to
http://user.fingertec.com/user-promanual.htm
for the TCMS V2 user guide online.
Setup Wizard will require you to do online activation before a connection can be
established between TCMS V2 and the terminals.
Connecting Terminals to the TCMS V2
deterMining the terMinaL nUMBer
Identify the number of your terminals to differentiate them between one another.
TCMS V2 can connect up to 999 units of terminal. Press Menu > Options > Comm
Opt > Dev Num > Select the number.
Using tCp/ip
IP address is important, as it is a unique address of the terminal in LAN. Without
the IP address, locating the specific terminal is not possible.
To input the IP ad-
dress of the terminal:
Press Menu > Options > Comm Opt > IP Addr > Key in IP
address.
setting Up ethernet
It is important to setup the Ethernet to connect the terminals using TCP/IP connec-
tion.
Setting up the Ethernet is done by enabling the Ethernet function:
Press
Menu > Options > Comm Opt > Ethernet > Yes.
Turn off the terminal after you have set the Ethernet setting to Yes. Now, plug-in
the network plug to the Ethernet interface and turn the power on.
Determining the Netmask, Gateway and NetSpeed:
For TCP/IP connection,
please configure the netmask, gateway and netspeed for the terminal.
Press Menu > Options > Comm Opt > NetMask > Insert the numbers.
Press Menu > Options > Comm Opt > Gateway > Insert the numbers.
Press Menu > Options > Comm Opt > NetSpeed > Choose the speed of your Eth-
ernet connection.