http:// en.fineart-light.com
- 13 -
Control panel
LCD control panel used for set address and fixture functions.
DMX Address set up
The DMX address, also known as the start channel, is the first channel
used to receive instructions from the controller. For independent control,
each fixture must be assigned its own control channels. Address sharing can
be useful for diagnostic purposes and symmetric control, particularly when
combined with the inverse pan and tilt options.
Two control mode: 23 channels and 31 channels.
FINE700 Spot color/gobo structure
Animation wheel
FINE700 Spot is equipped with 191160001 gobo, and there are other gobos
for choose.
Pic9 P/N:191160001 191160002 191160003 191160004
Animation wheel replacement
The replacement animation wheel can be inserted with the magnet in or
out to suit your application. In fixed applications, install the wheel with the
magnet forwards, away from the drive mechanism, for easier removal. In
touring or similar applications where the fixture is frequently moved, install
the animation wheel with the magnet in towards the drive mechanism for a
more secure hold.
①
Remove the gobo module as described on page 31(Routine maintenance:
Disassembly).
http:// en.fineart-light.com
- 14 -
②
Bring the animation wheel to the side of the module closest to you by
turning the black belt on the right as show in page 32.
③
To avoid bending the animation wheel while removing, break the
magnets initial hold by prying the wheel off with a screwdriver inserted
from the back. Once you have broken the hold, you can safely grasp the
wheel by the edge and remove.
④
Orient the replacement wheel with the magnet in or out to suit your
application (see note above this list). Place the wheel over the drive
mechanism and align the hole in the wheel with the drive pin.
⑤
Reinstall the gobo module. Verify that the guide pins are correctly seated
and that the module is securely locked.
Gobo wheel
Gobo wheel 1 provides 6 rotating gobos; gobo wheel 2 provides 9 static
gobos.
The standard gobo configuration is shown in Figure 10, and other gobos can
be replaced according to customers’ requirements.
Picture
10
Customization
To optimize effect, all gobos should be:
Outside diameter
：
---------------------
∅
27.9 +0/-0.2mm
（
1.1 +0/-0.01 in
）
Maximum gobo diameter
：
-----------23mm
（
0.9 in
）
