Page 2
Model: BR
-
40
-
SP
-
EC (5303154)
(40 Gallon Brush Buster Sprayer
)
•
40 Gal. Corrosion
-
Resistant Polyethylene Tank
•
PRO SERIES 12 Volt Diaphragm Pump, 2.2 GPM
-
100 PSI
•
Lever Handgun
•
16’
Vertical Throw,
30’
Horizontal Throw
•
15 Ft. Handgun Hose
Caution: Always check the vehicle load rating before using the sprayer.
The loaded weight of this sprayer is approx.: 370 lbs. when the tank is full.
Contents
Technical Specs and Assembly Instructions
.................
2
Troubleshooting
...................................................
4
-
5
Operation and Maintenance
..........................................
3
Sprayer Exploded View/Parts List
.............................
6
Tank Care and Winter Storage
......................................
4
Sprayer Dimensions
...................................................
7
Pump Exploded View and Parts List
.............................
5
Warranty
.....................................................................
8
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~IMPORTANT~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Remove tank lid and be sure the tank is clean and free of any foreign material. Rinse tank out of any tank residue before filling with
water to test.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~IMPORTANT~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
It is VERY important to test this sprayer with plain water before actual spraying is attempted. This will enable you to familiarize
yourself with the sprayer and check for leaks without the possibility of losing any expensive chemicals.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~WARNING~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Read and Understand
the Owner
’
s Manual before using this sprayer. Test and use in accordance to instructions.
Read and Follow
chemical label instructions and wear
protective gear when filling, using, cleaning and servicing the
sprayer.
Exercise Caution
in vehicle handling when towing/hauling a filled sprayer to avoid loss of control or overturning.
Keep Sprayer and Spray materials
away from other people, children and pets.
Do Not Turn on Power
to the sprayer, until ready to spray in order to avoid unintentional spray release.
Do Not Use
on steep slopes. A full sprayer could cause loss of control or overturn sprayer and vehicle.
Always operate
up and down a slope, never across the face of a slope.
Keep all movement on slopes
slow and gradual. Do not make sudden changes in speed, directions or turning. Do not start or stop
suddenly when going uphill or downhill.
Stop on level ground,
set the parking brake and shut off engine before leaving the operator
’
s position for any reason.
Keep all parts
in good condition and properly installed. Fix damaged or warn parts immediately.
Caution should be taken
when towing and/or using any sprayer. This sprayer combined with the weight distribution, turning radius
and speed of vehicle can result in damage to vehicle and/or sprayer or severe injury or death, if not used properly.
Improper use of this sprayer or handling of chemicals could result in serious injury or illness, or could cause damage to the
environment.
Assembly Instructions
The sprayer has been mostly assembled at the factory.
•
Attach the wand clips to the tank. Place a screw in the hole in the clip and bring up to the tank.
Use a phillips head screwdriver to secure the holders in place.
**Do Not Over
-
Tighten**
Do not use excessive force when placing the handgun into the clips, as this could cause breakage.
•
Make sure all hose clamps are tight before testing or spraying for the first time.
•
One requirement will be to hook up the battery leads to a fully charged 12 Volt battery.
•
The drain plug assembly should already be attached to the tank.
**The Sprayer is now ready to TEST w/plain water before actual use**
