Fimap MY50, Руководство по эксплуатации и обслуживанию

Страница: 18 / 36

18
PREPARATION OF MACHINE
21. ADJUSTING THE SQUEEGEE SUPPORT HEIGHT
The height of the squeegee must be adjusted on the basis of the state of wear and tear of the rubber
blades.
Carry out the following operations for adjustment:
1. Unscrew the locking nut
2. Raise or lower the wheel (1) by sliding it on the slot of the support
3. Block it by tightening the locking nut once the required height is reached.
NB: to facilitate the operation, completely lower the squeegee and put a spacer of a few millimetres (2 to 4
mm depending on the type of rubber) under the wheel.
22. DISC BRUSH ASSEMBLY
1. Make sure the dirty water recovery tank is empty; if necessary, empty it completely.
2. Connect the battery connector to the machine connector (battery-operated version)
3. Connect the extension cable to the electric system cable, then connect the extension cable to the
mains socket (electric version)
4. Press the main switch to “ON”
ATTENTION: During this operation, check there are no people or objects near
the brush.
5. Position the brush on the floor, near the machine brush head
6. Raise the brush head by using the handlebars as a lever
7. Place the brush head above the brush
8. Pulse press the dead man's lever to engage the brush to the brush head
WARNING! During this operation, check there are no people or objects
near the brushes.
ATTENTION:
users are advised to always wear protective gloves, to
avoid the risk of serious injury to hands.
1