13
MACHINE PREPARATION
To connect the batteries you must:
1.
Make sure the dirty water recovery tank is empty; if necessary, empty it completely
2.
Make sure the switch is in the OFF position
3.
Take the machine to the designated machine storage place
WARNING: park the machine indoors, on a flat and level surface; near the
machine there must be no objects that could either damage it, or be damaged
through contact with it
4.
Remove the protective cap from the battery charger connector socket on the back of the machine (1)
5.
Plug the battery charger cable (supplied with the machine) into the freed socket
6.
Plug the battery charger cable into the mains socket
7.
Follow the instructions in the enclosed booklet for the correct use of the battery charger, located
inside the casing that covers the electrical system
WARNING: If one of the three LEDs flashes refer to the battery charger
manual supplied with the machine
WARNING: The machine is equipped with an automatic system that
disconnects the power supply from the electrical system while the batteries are
being recharged
WARNING: In order not to cause permanent damage to the batteries, it is
essential to avoid their complete discharge: arrange the recharge within a few
minutes of the switching on of the flashing "discharged batteries" signal
WARNING: Never leave the batteries completely discharged, even if the
machine is not being used
WARNING: For the daily recharging of the batteries, you must fully respect the
indications provided by the manufacturer or retailer. All installation and
maintenance operations must be carried out by specialised personnel.
WARNING: Carefully read the use and maintenance manual of the charger
that is delivered inside the bag containing this instruction booklet.
WARNING: Before inserting the charger power cable into the socket, verify
that there is no condensate or other forms of liquids.
WARNING: danger of gas fumes and the leakage of corrosive liquids
WARNING: danger of fire: do not go near with free flames.
1
