FilterStream AirTamer A600, Инструкция по эксплуатации

Страница: 10 / 24

Page 8
AirTamer®
Insert the 6.
AIR FILTER
by placing the bottom
of the
AIR FILTER
inside your AirTamer and
pushing it past the large front rubber tab.
Then push the top of the
AIR FILTER
past the
large front rubber tab at the top of the unit.
NOTE:
make sure ThaT The air floW arroWs oN The filTer
face ToWards The froNT of The uNiT.
Replace the 7.
AIR EXIT GRILL
.
Place the unit on a level floor, keeping it 8.
at least 4” (10.2 cm) away from any wall,
furniture or appliances. Position the unit so
that the clean air will flow to your desired
area (clean air flows from the front of the
unit). Ensure that the
AIR INTAKE GRILL
and
AIR EXIT GRILL
are not blocked.
Power On/Off
The 1.
POWER CORD
is shipped as two pieces.
Connect the two pieces, plug the end with
wall outlet prongs into an electrical outlet,
and the round end into the
POWER JACK
located at the back of your AirTamer®.
Press the
2.
POWER BUTTON
to turn the unit
on. The
POWER BUTTON
will illuminate
when on.
Fan Speed
Your unit will initially start at the highest speed – Speed 5. Select your
desired fan speed by pressing the corresponding
SPEED BUTTON
.
Your AirTamer® has five (5)
SPEED SETTINGS
1, 2, 3, 4, and 5.
SPEED 5
will provide the highest rate of cleaning performance, but more noise.
SPEED 1
will provide the least amount of noise, but a slower rate of cleaning.
Normally, the lower speeds are ideal for sleep or relaxation environments.
7
6
HW_A600_UserMan_ENG_09.indd 8 5/11/09 2:25:04 PM