96
FCP-75 Manual —
P/N LS10147-003FK-E:A 3/17/2021
Programming
System Options
2.
Select 7 for Program Menu.
3.
Select 5 for System Options.
4.
From the System Options Menu, select 2 for Day/Night Sense.
A screen similar to the one shown in “Changing Day/Night Sensitivity Time” on page 96 will display.
Figure 9.11 Changing Day/Night Sensitivity Time
9.6.3 Holiday Days
Up to 18 dates can be designated as holidays. When day/night sensitivity is enabled, all photoelectric smoke detectors in the system will use
night sensitivity for the entire day on days designated as holidays (see Section “Holiday Days” on page 96).
To add or change a holiday, follow these steps.
1.
Enter the Installer Code.
2.
Select 7 for Program Menu.
3.
Select 5 for System Options.
4.
Select 3 for Holiday Days.
5.
Select the holiday schedules you wish to edit (1- holidays 1 - 9, 2- holidays 10 - 18).
Figure 9.12 Edit Holidays Screen
6.
Enter the month of the Holiday, then press ENTER.
7.
Enter the day of the month for the Holiday, then press ENTER.
8.
Repeat steps 6 and 7 for any remaining holidays you wish to program.
9.6.4 Time Options
Through this programming option you can set the water flow delay time, low AC report delay, enable or disable automatic daylight savings
time adjustment, clock format, and AC clock frequency.
Water Flow Delay
You can program a delay of 0-90 seconds (zero means no delay) to be used in conjunction with a water flow switch. The delay is system-
wide. All water flow switches on the system will use the same delay period.
To access the screen for programming water flow delay, follow these steps:
1.
Enter the Installer Code.
2.
Select 7 for Program Menu.
3.
Select 5 for System Options.
4.
Select 4 for Time Options.
NOTE:
For most installations, holiday programming will need to be performed each year to ensure correct dates.
Pre-programmed
Holidays
Programmable
Holiday locations
