106
FCP-75 Manual —
P/N LS10147-003FK-E:A 3/17/2021
System Operation
Operation Mode Behavior
10.6 Operation Mode Behavior
The control panel can display any one of the following seven conditions at any given moment:
•
Normal
•
Alarm
•
Prealarm
•
Supervisory
•
Supervisory
•
Trouble
•
Silenced
•
Reset
Table 10.1 describes the behavior of the panel in each of these modes.
Operation
Mode
Occurs When
System Behavior
In This Mode You Can
Normal
No alarm,
supervisories or
trouble con-
dition exists and
Menus are not
in use.
SYSTEM POWER LED is on.
The All Systems Normal display indicates that the system is
in normal mode.
The current date and time display on the last line of the LCD.
Enter the appropriate code, or rotate the key to activate
the Main Menu.
Alarm
A smoke
detector goes
into alarm or a
pull station is
activated.
CO detector
goes into alarm.
If more than 3
categories are
active at a
single time
screen will
display as
shown.
The communicator seizes control of the phone line and calls
the central station.
The on-board annunciator sounds a loud, steady beep (any
notification devices attached to the system will also sound).
GENERAL ALARM LED flashes.
The LCD displays a screen similar to this one.
Press the down arrow to view the alarm. A screen similar
to this one displays.
Press SILENCE and enter an Access Code (or activate
the key) to silence the annunciator (and any notification
devices attached to the system).
When the alarm condition clears, press RESET and
enter a code (or activate the key) to restore the panel to
normal.
Table 10.1 Panel Modes
